• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Small wish for MCX

tsgucci

tsgucci

Messages
482
Country
hungary
Hi Arno,


Small wish from my side.

It would be nice if MCX would remember for the coordinate/altitude/heading previous entry at Convert/Placement and earth curvation wizzard.

Thanks a lot!
 
Hi,

I think that should be possible as well, although now it just uses the defaults you specify. I'll put it on the wish list.
 
arno said:
Hi,

I think that should be possible as well, although now it just uses the defaults you specify. I'll put it on the wish list.
Click to expand...

How about 'PLACE AT AIRCRAFT COORDs' when connected to FS? That might be cool as well.
 
Reading the position from FS is already on the wish list.
 
You must log in or register to reply here.
Back
Top