• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Smoothing Problem

Messages
292
Country
unitedkingdom
I have a problem with smoothing, the aircraft model I am working on has a radar pod under the starboard wing, I shaped the pod & extruded from the top the part that joins the wing, I cant get the extruded polys to smooth, I even detached them from the radar pod to see if they would smooth but no, I have deleted all of unwanted polys.

Thanks in advance.
 
Solved, I didn't think until after posting the possibility of extra vertices being created during the extruding process & sure enough this was the reason, I welded these extra vertices & everything smooth's OK, I will remember to check for extra vertices after future extrusions.
 
First time I hear that an extrusion adds vertices. Booleans, ShapeMerge, yes, Extrusions, no. Of course, the extruded section is unsmoothed at first, one has to assign a smoothing group to it, usually a different one from the one used before.
 
Sorry, I should explain that I did not delete the polys from inside the hole before extruding, which I should have done, this resulted in polys being extruded inside the hole & when these polys were deleted, the vertices remained, a rookie mistake!!!!
 
Back
Top