• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Symmetry mode

sunayk

sunayk

Messages
170
Can you use the symmetry mode?

I can't get it to function (I have 3.5.1.).
May be I am missing something.
Thanks for any tip.
Sunay
 
I have never really used this feature, I am sure the aircraft designers could explain this better.

Make a tube like the screen shot than make the settings in the second screen shot and you should get the idea.

H_Farfy
 
Last edited:
Thank you Scott :)
I was trying it in the "point" mode, from your ss I saw it functioning in the "cross section" mode. It works :)
Will be useful for the fuselage of the static B707 that I am modeling.
Cheers
 
You must log in or register to reply here.
Back
Top