• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSXA Texture map joint issues

Messages
468
Country
ca-ontario
Hi folks,

LDR Development have recently taken on the task of converting Milton Shupe's Mallard to FSX native but we've run into issues once we activated the spec and bump maps on the fuselage and wing textures. I've attached a file showing the problem in the aircraft selection menu and it appears the same way in the sim. We had a similar issue with the Navion early in it's development but I can't remember how I fixed it (I have some short term memory issues due to my illness).

In the screenshot you can clearly see where the fuselage and nacelles have been split for mapping purposes (i.e. top, bottom and 2 sides) and the lighting changes dramatically along the seam edges.

The parts are welded and they are on two texture sheets (fuselage + fin and wings + nacelles). We have also tried testing with a known good bump map from the Navion to see if that was the issue with no luck.

Has anyone seen this before and if so what is the fix.

Thanks.
arg.jpg
 
Probably spec map format?

Try creating the spec map with Imagetool from a .psd file instead of exporting directly from Photoshop.
 
Are you 100% sure the alpha values are the same for the spec textures on both the fuselage pieces?

Also, how are you calling the fresnel ?

- Joseph
 
Oh dear..

Strange indeed. Certainly a model issue, it would seem then. Hopefully someone else will have some better advice!

- Joseph
 
You mention the parts being welded..
There must be a left-over material parameter of some kind, still associated with those upper pieces.
 
Hmm, the bumps look okay for both shades of grey. If it were a welding issue it would be more local and obtrusive, I suppose. Is it a multi-material perhaps? You could test whether the polies on one surface have a different ID than those on the other. You could make the diffuse, specular and both alphas the same grey color, re-create the .dds and see whether the effect goes away. If so, the fault would be in your current .dds. If not, post a piece of the fuse and the dds so that people here can check the material settings.
 
It's fixed! It looks like it was a bad bump that caused it, possibly during creation. A friend built a new bump from the source texture and the problem went away.
 
Not really bizarre as bumps are a touchy subject. The Photoshop people can export them directly from PS, but everyone else should let Imagetool handle the conversion.
 
Back
Top