• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Contact point

Messages
126
Country
italy
When I do a merge between planes, how should I change the contact point? I have read around that I have to consider the reference datum position. I have not figured out how.
If for example I have a plane with a reference_datum_position = 97, 0, 0, and with the following contact points: point.0 = 1, -24194, 0000, -21246, 1500.0, 0, 1.932, 56.0, 1.45 0.128, 0.780 , 9.0, 12.0, 0, 270, 320.
I want to merge with a plane that has the reference datum position = 111,0,0.
How do I change the contact point?
 
The old model's reference point has an x value of 97, the new one has 111, an increase of 14. Decrease the contact point's x value by 14, from -24194 to -24208.

But that model is apparently the size of Idaho...
 
Last edited:
Milton had a good system. You can assign NAV lights to your contact points to see where they are at. Easier to track.

What I do is set the time of day where the sun is barely up, on the horizon. Then I sit on the tarmac (runway, solid ground, or tires go in the ground a bit). Then you can see the true height of the contacts and start making changes, reload, change, reload till its right. (Bill Lyons taught me that). :)

A good drive through the dirt will show you how far forward or back your contact point is, so drive off the runway into some dirt and check your dust kickups for fore/aft checking.
 
Here is a SimConnected tool that will display lots of positional information in "Real Time" via FSX/P3D "Spot View." Simply unzip this simple executable into a folder of your choice (I use C:\DATA\FS_Tools). Launch visualizer.exe before or after FSX or P3D is running. Enable/Disable any of the options, and a red 'cross-hair' will magically appear in Spot View for your reference.

https://files.secureserver.net/0sDKb4YpWXrR5R
 
Is there something similar for FS9?
Unfortunately, no there is not. Sim Connect is required to link the program to FSX or P3D. FS9 folks will have to use Milton's suggested method using .fx "lights" to assist in setting contact points.
 
I was able to adjust the contact point with the method of Milton. But now I have a small problem: The plane turns with difficulty; and as if he was on the ice.
 
Last edited:
Back
Top