• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS20 FS2020 with arduino

S

sbertolo

Messages
2
Country
spain
Hello:

I´m developing a interface between Simconnect and Arduino. In the arduino there are the pilot panel with intruments flight controls like in G1000 GPS

Anybody know if the G1000 events are working in Simconnet with FS2020?

I´m trying to send this commands but i don´t have any response.

Thanks
 
Hello,
I only made tests with FSUIPC 7 and it seems that most of the buttons don't react at all... FREQ change is OK. It seems that there is a kind of mystery with the MSFS G1000...
 
Hello Chaly, thanks for your feedback, I trying lots of AP events, but only a few give me response. In the developers area in FS2020 i´m trying to find the simconnect logs but i can´t find any of those.

Are someone experienced in the tool?..
 
You must log in or register to reply here.
Back
Top