• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Hangar with lights

  • Thread starter Thread starter l52
  • Start date Start date
Cecked again ... no, it doesn't show up.
Changed the effect and used "fx_Orbx_Obstruction_Red_2s" and it doesn't show in FSX while it shows up in MCX.
Made a short test with a different blender file, followingg exactly the same procedure, but in a different location, and "fx_Orbx_Obstruction_Red_2s" showed up ....


I think i will give up .... :( :( :(
 
Hi,

I have very little experience adding effects, but I'd imagine that the actial effect (the light) would be in the middle of the plane. Seeing that the middle is covered by those struts/beams I would think the effect is blocked by it (?)
So it you move the middle away from those beams a bit, will it be vissible?
 
Hi 747fly .... Once the plane is used as attach point it becomes invisible allowing the obstruction light to be fully visible .... when is visible ! :)
I made a new .blender file, consisting just in the 3 attach point planes; created the attach points exactly as before; made a new .bgl and located exactly where the stack is .... and this time the obstruction lights are visible on top of the stack .... :eek:
 
Last edited:
You must log in or register to reply here.
Back
Top