• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS20 No Taxi Lights when adding a Taxiway.

Are you adding edge lines with your taxiways? If your taxiways does not have edge lines, then this is not an ADE issue, but an MSFS thing.

I use the default editor in MSFS quite often and the only way to get taxi edge lights is to add edge lines to a taxiway. The alternate is to draw the lights in with a light strip if the taxiway does not have edge lines.

Regards,
 
yes i have tried it with edge lines and without, i tried adding light strip too and that wont show up.
 
I can't see them so I will ask ASB about it. It's not ADE as far as I can tell
 
I have had some success with taxiway lights when designated in apron path properties, but it has been unpredictable. The only sure way to get them to appear and to appear where you want them is to place apron lights individually. The individually placed lights must be outside the width of the path to appear, otherwise they sink into the ground.
 
I was refering to the way we used to add taxiways with lights like we did with ADE for FSX, and was hoping for the same with ADE for MSFS 2020
 
Microdude said:
I was refering to the way we used to add taxiways with lights like we did with ADE for FSX, and was hoping for the same with ADE for MSFS 2020
Click to expand...
The properties and attributes still exist to create lighted tawiways in MSFS 2020 but it seems they are not honored/ignored. I will have to ask about this along with a bunch of other stuff
 
You must log in or register to reply here.
Back
Top