• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 part motion drift?

Messages
231
Country
us-alabama
I am having a problem with a gun charging knob animation. I am keyframing it:

kf 0-30 rotate +75 degrees on z axis, kf 30-40 move left 1/4" on x axis, kf 40-50 move right 1/4" on x axis to original x axis position, kf 50-80 rotate -75 degrees on z axis to original z axis location, kf 80-90 move left 1/4" on x axis, kf 90-100 move right 1/4" on x axis to original x axis location.

When I play the animation in the sim, the x axis movement starts at the zero and plays continuously thru the entire 100 frames. The sim does not seem to be reading the stop/start frames for the x axis movements.

Can anyone tell me what is going on? Is this combination of rotation and movement too complex for the sim. Or more likely, am I screwing something up.

Carl
 
Try Key Frames 0-30; 31-40; 41-50; 51-80; 81-90 and 91-100.
and seperate the motion into discrete lumps.

Regards, Ted.
 
If using GMAX, make sure that your animation controllers for rotation and moving are set to Linear controllers. It's the little black box with an arrow in it at the top of the Animation tab on the right. Click on the animation type first.

If using FSDS, keep adding keyframes as mentioned above until the motion is what you want.

Hope this helps,
 
Ted
I have tried framing it that way and several other ways also. I have been working on this for a week now. Trying to give my editor/beta tester historic accuracy.

tgibson

All of my animation controllers are set to linear. First thing I do when I get ready to animate/frame a part. I had wondered if the stock gmax settings would do better and tried them too, 4 or 5 .mdls back, no joy there.

Carl
 
One thing to try would be to place a small box inside the knob, and use that to animate the in and out movement. Once that is working well, animate the knob for the turning movement only. Then make the knob a child of the box (linking).
 
Using that in current version. No joy there either. I've tried that sort of linking the knob with rotational animation to a movement part, several times over the last week. I think I have also tried every key framing combination short of animating it frame by frame thru the 100 frames of the sequence .What ever I try I still get the drift.

Carl
 
Back
Top