I have tried searching for an answer to my problem, but without success, what I would like to know is how to texture an aircraft fuselage using 2 texture sheets, one for the left side & one for the right, all the fuselages of the models I have made in the past have been put on to a single texture sheet which is easy, just UVW map each side separately, but I am confused about how I go about UVW mapping 4 or 5 different sections of the fuselage, the 5th is the belly. The only way as far as I can see of doing this is to split the fuselage into two separate parts (left & right), but this would end up looking messy.
The reason for wanting to use two texture sheets is because I want to put the front sections of the fuselage in the top part of the texture sheets & the rear section on the bottom so I can have higher resolution textures from the 1024x1024 max texture size.
Any advice will be much appreciated.
Paul
The reason for wanting to use two texture sheets is because I want to put the front sections of the fuselage in the top part of the texture sheets & the rear section on the bottom so I can have higher resolution textures from the 1024x1024 max texture size.
Any advice will be much appreciated.
Paul


