-
Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:
- Tag FS2020 specific questions with the MSFS2020 tag.
- Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
- Questions about aircraft design can be posted in the Aircraft design forum
- Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
- Questions about terrain design can be posted in the FS2020 terrain design forum.
- Questions about SimConnect can be posted in the SimConnect forum.
Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.
ADE9
- Thread starter Mario
- Start date
?????
What that post was saying is that the GP Editor image you posted initially could not have been prompted by the file you sent. Perhaps when you found things didn't turn out as expected you neglected to save the file that did prompt that image
tgibson
Resource contributor
- Messages
- 11,343
- Country
-
How to draw a GP line on an apron. in ADE
1. Create the apron.
2. Click on the button that has a tooltip saying "Add Custom Ground Line" - it has a picture of a line and a cross with a little "G" underneath it.
3. Draw your line - (left) click, click to create the first segment, click again to create the next segment, etc. Double click the last point to end the line.
4. The GP Line Editor will appear. Set the Line Width.
5. Choose the Main Texture.
6. Select the Line Pattern/Style. If this list is empty, then you have not chosen a Line texture.
7. When you do this, your line will suddenly become a vertical line - that's OK.
8. If you wish your line to have an "edge" on both sides (like a black edging on both sides), set the Backing Width and Select a Backing texture. If not, leave them blank.
9. Click OK.
1. Create the apron.
2. Click on the button that has a tooltip saying "Add Custom Ground Line" - it has a picture of a line and a cross with a little "G" underneath it.
3. Draw your line - (left) click, click to create the first segment, click again to create the next segment, etc. Double click the last point to end the line.
4. The GP Line Editor will appear. Set the Line Width.
5. Choose the Main Texture.
6. Select the Line Pattern/Style. If this list is empty, then you have not chosen a Line texture.
7. When you do this, your line will suddenly become a vertical line - that's OK.
8. If you wish your line to have an "edge" on both sides (like a black edging on both sides), set the Backing Width and Select a Backing texture. If not, leave them blank.
9. Click OK.