• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS How to properly implement MARS in MSFS2020?

TulparSim

TulparSim

Messages
9
Country
turkey
Hello,

MARS system, Multiple Aircraft Ramp System, is used widely in Turkey. Especially in Istanbul, this is crucial. It doubles the terminal gate capacity. Question is:
1- How to properly implement this system in MSFS 2020 sceneries?
Is putting 2 mediums and 1 heavy at the same spot enough? Example picture below. What is the correct way to achieve this? (Satellite image attached below)
1674898264867.png


Satellite image:
1674898503785.png


2- How to achieve this behaviour with the jetways? As it can be seen from the satellite image above, when there is a widebody parked at main gate, both jetways are connected. When 2 narrowbody/mediums are parked at L and R respectively, one jetway per aircraft is used. Is there a way to achieve this behaviour in MSFS 2020?

Thank you.
 
The big question is how to utilize the jetways, because I do not think setting up the gates is a big problem considering first image shows some sort of solution (I did not try this before).
 
Last edited:
You must log in or register to reply here.
Back
Top