• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Yellow stripes on taxiway edges

Messages
48
Country
bahrain
Hello Gents,
I am looking to create yellow stripe lines as in the picture attached. Are we supposed to paint each line individually or is there a way around it?

1714733875162.png
 
You can experiment with adding custom materials in the painted line properties using the material editor.

Many UK airfields have similar but are smaller and closer together.

These are the ones I use for that. Can't remember which painted line in the dropdown box makes them show up. It might be service line dashed. If it isn't, it'll show up eventually.

You'll probably need a lot of trial and error to find something that works but at least it only takes a short time to try a new one.

The way the lines work is that the SDK uses narrow sections of one single texture often with different sections combined, so your own full-sized hatch line may not work as it may be too wide or fiddly.

Worth a try though.
 

Attachments

  • left.png
    left.png
    9.4 KB · Views: 28
  • right.png
    right.png
    11.4 KB · Views: 34
Last edited:
Back
Top