• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

MSFS20 Default scenery doesn't come out after build

L

Lee Cley

Messages
7
Country
brazil
Default scenario doesn't come out after build

Default scenario does not exit and leaves duplicate PAPI, TAXI LIGHTS, TAXI LINES, APRON, WINDSOCK;

It is also not possible to remove the FUEL STATION!

I've already put exclusion rectangle and exclusion polygon and it doesn't solve!

can anyone help? I have already created a new project and the problem persists!


Screenshot_18.png
 

Attachments

  • Screenshot_19.png
    Screenshot_19.png
    2.3 MB · Views: 105
  • Screenshot_20.png
    Screenshot_20.png
    2.4 MB · Views: 102
To exclude the windsock(s) you will need to use an exclude poly. I personally set excludeSimObjects, excludeLibraryObjects, and excludeWindsockObjects, but the latter is probably all you need. I've just never tested which of the 3 works.

As far as everything else: If you click on your airport in the Scenery Editor and scroll all the way to the bottom of it's properties window, you will see a section called "Delete command". Check off all that I have and you should be set!

delete.PNG
 
I made the exclusions in the airport configuration, the scenario was right already finished and after the last update this bug occurred!

I already went to the site and created the project again, I do the deletions as usual, in the project add all the defaults, but when I put the scenario in the community the default is below, giving conflict!
 
Hello Lee,

I was seeing some similar idiosyncrasies, and discovered (for me) that if your (previously edited) folder is in your community folder while you're making new edits then sometimes you'll get doubling or odd, unwanted results after a build.

Try editing with your previously edited project not in the community folder, then build, then exit MSFS2020 completely.

Then copy the newly built folder to your community folder, and restart MSFS2020 and check your results; it's possible this may be your problem.

Cheers, K99
 
You must log in or register to reply here.
Back
Top